Display Point type

Answered

• July 07, 2022 02:14

Is it possible to display point type when click point on Route

Whether it's for external sensor or not 

 

Vote 1 Votes

• 

  • July 07, 2022 13:52

  Is the point type not seen in the image.

  This to me is very poorly designed it is very boxy and cumbersome to use. Why the user sees 'Measurement Location' after the '03AV DE' in all of the boxes, it SHOULD not be seen as it is of no value to the user at all. 

  Regards, IanBlack
• 

  • July 08, 2022 06:47

  Hello,

  The point types are listed under the Measurement configurations for the device. When you click on "Edit", you will also see if you have selected an external or internal sensor. In the hierarchy tree we only show the measurement locations, then the points are defined for the device.

  When it comes to your second remark about the boxy design of the tree, we need to write "Measurement Location" after the name, since we also have Lubrication Points and Inspection Points, and the users need to see which types they are looking at.

  If you have any further questions or remarks, feel free to reach out to me.

  Carolina
• 

  • July 08, 2022 09:34

  Hi, thanks for the reply and understood.

  Can ‘Location &  Point ‘ be dropped off the end as it is obvious to the user what kind of measurement is being made, as a appropriate name is then set.

  It is not seen anywhere and takes up space in the Box 

  Regards, IanBlack
• 

  • September 16, 2022 11:37
  • Edited

  There are far too many duplicate words in all of these boxes, it causes the user to look at a meaningless word, which is like a grey ladder, not good viewing.

   

  Easy solution, don’t show them or set them as per the background  - white!

Please sign in to leave a comment.