Enlight Centre and ProCollect - QR codes

Planned

• April 22, 2021 08:20

The QR scan has been introduced, when a Asset is subsequently linked using the Data collection device, it does find the machine in say a '100 Asset Route with several Function locations', once it has been downloaded again. But, once the linked Asset is found and CM data is collected, it moves onto the next Asset in the Route listing only. 

This is due to the way the Asset and measurement Location are all shown in a never ending Route list on the Data collection device.

So, the operator needs to navigate back to the 'QR Screen' to scan for the next asset etc, it doesn't make sense to use the QR because of this.

Would it not be better that the 'QR Scan' option was always visible on the 'Bottom Toolbar' or a better way for the operator to use this QR option, as at the moment it is not that helpful.

 

Br Ian Black

Vote 5 Votes

• Official comment

  

  • May 10, 2021 11:58

  Hi Ian! 

  Thank you for your feedback. This is a very good point where we need to improve the user experience. We'll take this into consideration in future development. 
• 

  • May 13, 2021 09:13

  That's good news

   

Please sign in to leave a comment.